| Dongguan Geli Tool Co.,Ltd 当前位置： 首页 >>News >>Technical information |
| Electronic ally plastic Soldering guns Manual |
| Electronic ally plastic Soldering guns Manual
Technical parameter:
Specified voltage: 220~240V frequency: 50/60Hz rated power: 500W 700W (two style)
Main use:
Plastic welding torch weld various kinds of plastic equipment and indispensable tool at maintaining the plastic equipment of form with plastic welding rod plastic board, this product is suitable for the section and accumulated and greater than 6 plastic welding rod to weld function. Can mix and chew with the spear while using.
Use the item:
1.There are temperature adjustment switches on the handle, twist to right " pa " In order to close the power after, twist to the left " pa " Green indicator lamp is on after, open the cold wind, when the red indicator lamp of and then twisting to the left etc. is on, begin to send the hot wind, until twisting it while moving, temperature reaches highest.
2.Use it in the course, regulate temperature in good time according to the need, pay attention to the distance between the spray nozzle and solder joint, reach the demand that the ideal welds.
3.While using for the first time, may smolder or take the Mars phenomenon, this phenomenon is belonging to the normal one. Disappear automatically several seconds later.
4.Should keep the tail of the welding torch entering the wind smoothly while using, otherwise is it generate heat core to be overheated to burn out to result in.
5.It weld after finishing,switch it twist it is to cold wind shelf (already red light put out after) ,Give the cold wind for a moment, make steel tube and generate heat core is it come down to cool, then shut-down. Can protect heating wire to be remaining energy too high to be it generate heat core burn out the lead wire after the life-span to influence effectively in this way. By finishing putting down to this product gently keeping, so as not to damage some refractory materials of welding torch, cause the heating wire broken and fall.
6. Such as generate heat core burn out, can is it shoot shell join screw is it generate heat the core to take out, needn't open the handle to fasten, change the generating heat of the same type core of our factory.
7. While using, there must be ground wire to join, guarantee the security.
Precautions:
1. Can't be in the moist environment work of air, so as not to get an electric shock.
2. Can't touch steel tube generate heat some, so as not to burn while using.
3. Forbid using and moldings the welding torch flammable, explosive article nearby, so as to avoid the contingency.
4. After finishing using, should keep and put the steel pipe carrier properly on the support, after complete cooling.
Related enclosure:
Generate heat the core one is extended and chewed one |
| 文章来源：http://www.juchetrade.com/te_news_industry/2009-06-28/763.chtml |